Zebra LS7708-BENU0100ZR Especificaciones descargar pdf (Pagina 12)

12 Symbol LS7708

Lo-hi-lo beep The Code 39 buffer was erased or there was an

attempt to clear or transmit an empty buffer.

Lo-hi beep A successful transmission of buffered data.

Host Specific

USB only

4 short high beeps Scanner has not completed initialization. Wait

several seconds and scan again.

Scanner gives a power-up

beep after scanning a USB

Device Type.

Communication with the bus must be

established before the scanner can operate at

the highest power level.

This power-up beep occurs

more than once.

The USB bus may put the scanner in a state

where power to the scanner is cycled on and off

more than once. This is normal and usually

happens when the PC cold boots.

RS-232 Host only

1 short high beep A <BEL> character is received and Beep on

<BEL> is enabled.

RS-232 Auxiliary Port only

1 short high beep A complete block of data was received and sent

to the host, either due to a carriage return or

because the two-second serial response

timeout has elapsed.

4 long low beeps A data overrun condition has occurred. Abstain

from scanning data from other ports when large

amounts of data are sent to the RS-232

Auxiliary port.

Beeper Sequence Indication

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sin comentarios

Zebra LS7708-BENU0100ZR Especificaciones Pagina 12