Zebra MC75 Guía de usuario Pagina 155

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 202
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 154
Accessories 6 - 19
Cables
This section describes how to set up and use the cables. The cables are available with a variety of connection
capabilities.
The following communication/charge cables are available:
Serial (RS232) Charge cable (9-pin D female with power input receptacle)
USB Client Charge cable (standard-A connector and a barrel receptacle for power)
Auto charge cable
DEX cable
Modem inverter cable
Charge only cable.
The following printer cables are available directly from Motorola:
O’Neil Printer cable
Zebra Printer cable.
Figure 6-21
Cables
Communication/charge cables:
Provide the MC75 with operating and charging power when used with the Motorola approved power supply.
Synchronize information between the MC75 and a host computer. With customized or third party software, it
can also synchronize the MC75 with corporate databases.
Provide serial connection through the serial pass-through port for communication with a serial device, such
as a host computer. For communication setup procedures, refer to the MC75 Integrator Guide.
Provide USB connection through the USB pass-through port for communication with a USB device, such as
a host computer. For communication setup procedures, refer to the MC75 Integrator Guide.
Dedicated printer cables provide communication with a printer.
Battery Charging and Operating Power
The communication/charge cables can charge the MC75 battery and supply operating power.
To charge the MC75 battery:
1. Connect the communication/charge cable power input connector to the Motorola approved power source.
Vista de pagina 154
1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 201 202

Comentarios a estos manuales

Sin comentarios