Zebra 160S Guía de usuario descargar pdf (Pagina 72)

Upper Transmissive Media Sensor Position Adjustment

To adjust the upper media sensor, refer to Figure 7.2 and follow these

steps.

1. Remove the ribbon and locate the Upper Media Sensor.

2. Loosen the Phillips head screw.

3. Slide the upper sensor along the slot to the desired position. When using

media that has a web between labels, position the media sensor anywhere

along the web (except if you have labels with rounded corners, do not posi-

tion the sensor where the rounded corners of the label might be detected).

When using tag stock, position the upper sensor directly over the hole or

notch.

4. Tighten the Phillips head screw.

Note: To adjust the upper section of the Transmissive Media Sensor

for the outside half of the media width, call a service

technician.

Zebra S-Series User’s Guide 7-3

Figure 7.2 Upper Media Sensor (105Se shown)

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 105 106

Sin comentarios

Zebra 160S Guía de usuario Pagina 72