Zebra Cameo series Guía de usuario

Part # UMAN-CM2/3 Rev. P, Jan. 2004User Guide

O-4UMAN-CM2/3continued next pageRemoving and Replacing Cameo 2 Battery PacksTo remove the battery pack from the Cameo 2:1.Push the battery release but

O-5 UMAN-CM2/3Removing and Replacing Cameo 3 Battery PacksTo remove the battery pack from the Cameo 3:Slide the Battery Latch button in the direction

O-6UMAN-CM2/3MEDIA INSTALLATION (CAMEO 2 SHOWN)Squeeze fingergrips here onboth sides toopen coverFeed media inthis directionAdjust edgeguide to de-sir

O-7 UMAN-CM2/3INSTALLATION OF MEDIAThe following details media installation:Cameo 2 is illustrated. Loading procedure is identical for allunits.1.Tu

O-8UMAN-CM2/3MAGNETIC STRIPEFACES OPPOSITESIDEDetail "A"- Top view of printerFlashing lightmeans O.K. toscan cardMAGNETIC STRIPE READERThe o

O-9 UMAN-CM2/3The Smartcard reader (only available on CameoSCmodels ) is used as follows:1.A status light indicates the Smartcard reader isavailable.

O-10UMAN-CM2/3Media SensorPrint HeadPlatenCLEANING THE CAMEO 2CLEANING THE CAMEO 3Media SensorPrint HeadPlaten

O-11 UMAN-CM2/3MAINTENANCECameo printers will provide years of reliable serviceprovided a few simple guidelines are followed. Theprinter should be cl

O-12UMAN-CM2/3Cleaning the Media SensorThe Media sensor is located inside the media compart-ment under the print head. Blow out any dust depositscare

O-13 UMAN-CM2/3TROUBLESHOOTINGSelf Test:Perform the self test as described in the Controls sec-tion. The unit should print a line of interlocking “x

iiProprietary StatementThis manual contains proprietary information of Zebra Technologies Corporation and itssubsidiaries (“Zebra Technologies”). It i

O-14UMAN-CM2/3• Network printers: refer to the RF LAN Information section ofthe Self Test printout to verify the printer’s SSID and IPaddresses are co

O-15 UMAN-CM2/3COMMUNICATING TO THE PRINTERThe printer must establish communications with a hostterminal which sends the data to be printed. Communi-

O-16UMAN-CM2/3logo on the lower left corner of the keypad.• By means of a wireless LAN (Local Area Network)(Cameo 3 Network Printers only) Cameo 3 Ne

O-17 UMAN-CM2/3continued next pageIR CommunicationsPrinters equipped for infrared (IR) communications areidentified by a small “IR” logo on the unit’s

O-18UMAN-CM2/3Wireless Communications with Bluetooth™ usingZBR RadioThe following section only applies when the Bluetooth ZBR Module (FCC ID: I28MD-BT

O-19 UMAN-CM2/3continued next pageNote: -Member states in the EU with restrictive use for this device arecrossed out!This device is also authorized fo

O-20UMAN-CM2/3Wireless Communications with Bluetooth™usingZBR-2 RadioThe following section only applies when the Bluetooth Module (FCC ID: I28MD-BTC2T

O-21 UMAN-CM2/3Europe – EU Declaration of ConformityThis device complies with the essential requirements of the R&TTEDirective 1999/5/EC. The foll

O-22UMAN-CM2/3Wireless Local Area Network (WLAN)Printers equipped for Wireless Local Area Network(WLAN) communications are known as Cameo 3N Net-work

O-23 UMAN-CM2/3PRINTER SPECIFICATIONSPhysicalCameo 2 Cameo 2SCCameo 3/ 3SC/ 3NHeight 6.6" (168 mm) 7.3” (185 mm) 6.2” (158 mm) (3)8.2” (208 mm)(3

iiicontinued next pageCONTENTSIntroduction ... O-1Controls ...

O-24UMAN-CM2/3Communications PortPin Pin Signal SignalNumber Name Type Description1RXD input Receive Data2 TXD output Transmit Data3 CTS input Clear T

O-25 UMAN-CM2/3Media Width settings available with edge guide (all dimensions ±.05” [±1.3 mm]Cameo 2 series Cameo 3 series0.72 (18.2 mm) 1.47 (37.3 mm

O-26UMAN-CM2/3Accessories and Options• Single battery pack fast charger/conditioner• Four battery pack fast charger/conditioner•Vehicle Charger• Extra

A-1APPENDIX AINTERFACE CABLESPin 1Pin 9DB-9 PinFemale Plug(to P.C.)8 PinMale Plug(to printer)(TXD)(RXD)(RTS)(CTS)(GND)(DTR)(DSR)Shield(RXD)(TXD)(CTS)

A-2APPENDIX AINTERFACE CABLESCable Cord Terminal PrinterTerminal Part Number Lgth/Type Connector Connector NotesCOMPSEEApex II BL12093-3 8’ Coiled RJ

APPENDIX AINTERFACE CABLES (continued)A-3Cable Cord Terminal PrinterTerminal Part Number Lgth/Type Connector Connector NotesSYMBOL (CONT.)LRT/LDT3800

A-4APPENDIX BMEDIA SUPPLIESTo insure maximum printer life and consistent print qualityand performance for your individual application, it isrecommend

A-5APPENDIX CMAINTENANCE SUPPLIESIn addition to using quality media provided by Zebra, it isrecommended that the print head be cleaned as pre-scribed

A-6APPENDIX DPRODUCT SUPPORTFor product support, contact Zebra Technologies at:www.zebra.comZebra Technologies International, LLC333 Corporate Woods P

A-7D275,286D347,021D389,178D430,199D433,7023,964,6734,019,6764,044,9464,360,7984,369,3614,387,2974,460,1204,496,8314,593,1864,607,1564,673,8054,736,09

ivEnvironmental ... O-23Printing Characteristics ... O-23C

Operation Section

Cameo 2 with optionalMag Stripe Reader andIR interface.Cameo 2SC with MagStripe Reader, SmartCard Reader and IRinterface.Cameo 3Cameo 3N (shown),Cam

O-1 UMAN-CM2/3INTRODUCTIONThe Cameo™2, Cameo 2SC , Cameo 3, Cameo 3SC andCameo 3N Mobile Printers utilize the latest in directthermal printing technol

O-2UMAN-CM2/3CONTROLSKeypad FunctionsOn Switch:momentary actionturns on unitIR Window;must be aligned withcorresponding window on hostfor IR communica

O-3 UMAN-CM2/3BATTERIES AND CHARGINGConditioning Battery PacksCameo batteries must be cycled several times beforemaximum capacity is realized.A batter