Zebra Eltron Card Printer Guía de usuario Pagina 100

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 112
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 99
Step 4. Adjust the Brightness Adjustment Screw by either loosening or tightening.
Remember the amount and direction of adjustment. If loosening, push the Head
Assembly until the adjustment screw again bears against the Print Head Yoke.
Step 5. Tighten the Head Fasteners in the sequence shown.
Step 6. Print another Test Card. Then compare the cards. Any improvement in
brightness signals a proper direction of adjustment. Conversely, any deterioration
in brightness indicates that the adjustment should have been in the opposite
direction or possibly that too great an adjustment placed the Print Head beyond
the optimum point.
Step 7. Repeat Steps three through six until an optimum brightness is achieved.
6-10 980264-001 Rev.B
CHAPTER 6
Figure 6-8. Image Brightness Adjustment.
Vista de pagina 99
1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 111 112

Comentarios a estos manuales

Sin comentarios