Zebra MtP400 Manual del operador descargar pdf (Pagina 14)

Getting Started

Belt Loop System

The belt loop system consists of two parts – a knob located on the bottom of the printer and a belt loop strap

with a click on connector

To use the belt loop system, slide your belt through the strap of the belt loop and then insert the knob located on

the bottom of the printer into the slot of the belt loop connector. Pull down on the printer until you hear a click.

The printer is now secure and can safely hang down beside your hip.

To release the printer, press in on the two latches on the sides of the connector and pull the printer and knob up

and clear of the slot.

Note: Do not force or pull the printer from the connector without pressing in on the two latches.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 64 65

Sin comentarios

Zebra MtP400 Manual del operador Pagina 14