Zebra MtP400 Manual de usuario descargar pdf (Pagina 30)

Printer Configuration

IrDA Interface

INTERFACE MENU

IrDA

Note that “IrDA” must be displayed on the bottom line of the display in order to access the following features

and for this interface to be active when Setup is exited.

Emulation

Printek

Possible Values: Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump

This feature sets the family of printer commands that may be used by a host application program to control the

various capabilities of the printer. The printer will only respond to commands valid for the currently selected

emulation. For more information, please refer to the MtP400 Series Programmer’s Manual.

Bluetooth Interface

INTERFACE MENU

Bluetooth

Note that “Bluetooth” must be displayed on the bottom line of the display in order to access the following

features and for this interface to be active when Setup is exited.

Emulation

Printek

Possible Values: Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump

This feature sets the family of printer commands that may be used by a host application program to control the

various capabilities of the printer. The printer will only respond to commands valid for the currently selected

emulation. For more information, please refer to the MtP400 Series Programmer’s Manual.

Note: After pressing the

Enter Button to move from Emulation to Pairing Mode, the printer will pause

and display “Waiting for Bluetooth” while reading the current configuration from the Bluetooth

interface module.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 62 63

Sin comentarios

Zebra MtP400 Manual de usuario Pagina 30