Zebra MtP400 Guía de usuario descargar pdf (Pagina 68)

Appendix L – Specifications

Black Mark Position

The vertical position of a Black Mark is dependent on the application program that will be used to search for

and print relative to the mark. The following diagram shows the optimum position when seeking the Black

Mark at the beginning of a print job and will require little, if any, reverse paper motion.

The Black Mark must be printed on the front side of the paper for the DP-550. It may optionally be printed on

the back side of the paper for use with the DP-550LP models

0.7092”

0.15”

Tear edge.

Front (thermal printed) side of

form.

Black Mark should span width

of paper for best results.

Figure 15 - Black Mark Position

Gap Sensing Specifications

Gap Sensing is only available for DP-550LP models. The minimum gap between labels is 0.125” (3.2mm).

1 2 ... 63 64 65 66 67 68 69 70 71 72 73

Sin comentarios

Zebra MtP400 Guía de usuario Pagina 68