Zebra PT40x Series Especificaciones descargar pdf (Pagina 31)

2SHUDWLRQ2YHUYLHZ 6HFWLRQ

$XWR&DOLEUDWLRQ

By default, this printer automatically sets the sensor levels and determines the length of

the label being used. To auto-calibrate:

1. Turn the printer On (O).

2. Load the media and close the printhead.

3. Press FEED. Two labels print, completing auto-calibration.

Auto-calibration works only when you are using non-continuous media (a gap or notch

separates each label).

Auto-calibration is performed when the printer is turned On (O) (if the printhead has been

opened) and whenever an error is cleared.

0DQXDO&DOLEUDWLRQ

Perform manual calibration whenever preprinted labels are being used or if the printer

does not auto-calibrate. To calibrate manually:

1. Turn the printer On (O).

2. Remove several labels from a section of the liner to thread the liner only through the

printer.

3. Press and hold FEED until the Error LED flashes once, then twice. Release FEED.

Refer to Table 2-1 for a complete listing of Feed Modes.

4. The printer sets the media sensor for the liner being used. After it makes this

adjustment, the roll automatically feeds until a label is positioned at the printhead.

5. Refer to Figure 2-19. A profile of the media sensor setting prints. Upon completion,

the printer saves the new settings in memory and the printer is ready for normal

operations.

1RWH7KHSULQWHUGRHVQRWDXWRFDOLEUDWHFRUUHFWO\ZKHQ\RXDUHXVLQJSUHSULQWHG

ODEHOV,IWKLVW\SHRIPHGLDLVEHLQJXVHGVHH0DQXDO&DOLEUDWLRQRQSDJH 

1RWH5HIHUWR7DEOH 3HUIRUPLQJDPDQXDOFDOLEUDWLRQGLVDEOHVWKHDXWR

FDOLEUDWLRQIXQFWLRQ7RUHWXUQWRDXWRFDOLEUDWLRQHLWKHUGHIDXOWWKHSULQWHURUUHIHUWR

\RXUODEHOSUHSDUDWLRQVRIWZDUHXVHUVJXLGH

1RWH:KHQXVLQJEODFNPDUNRUZHEODEHOVVHWWKHDSSURSULDWHVRIWZDUHFRPPDQG

VHH\RXUODEHOSUHSDUDWLRQVRIWZDUHXVHUVJXLGHEHIRUHSHUIRUPLQJDPDQXDO

FDOLEUDWLRQ

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 79 80

Sin comentarios

Zebra PT40x Series Especificaciones Pagina 31