Zebra MP6000 Información técnica descargar pdf (Pagina 347)

100

101

CHAPTER 7 AUXILIARY SCANNER BAR

CODES

Introduction

The parameter bar codes in this chapter, and the bar code defaults in Table 7-1, are solely for the MP6000.

These bar codes configure the MP6000 for connection to an auxiliary scanner. The auxiliary scanner requires

its own configuration, and should be programmed with matching settings found in the auxiliary scanner’s

Product Reference Guide.

In addition to these settings the auxiliary scanner must be independently configured as a stand alone scanner,

as though it were connected directly to a host. An auxiliary scanner connected to an MP6000 does not assume

the MP6000 configuration.

For detailed technical information about the MP6000 including installation, setting up interfaces, calibrating the

scale, and operation refer to the MP6000 Integrator Guide (p/n 72E-172632-xx).

NOTE Auxiliary RS-232 scanners should only be attached/detached when the MP6000 is powered off.

Table 7-1

MP6000 Auxiliary Scanner Connection Parameter Defaults

Parameter Default

Page

Number

Auxiliary Scanner Decode with Unknown Type Send Unknown as Code 39

7-2

Host Protocol Zebra Scanner Auto Switch

7-6

Baud Rate 9600

7-9

Data Bits 8 Data Bits

7-16

Stop Bits One Stop

7-18

Parity No Parity

7-20

Host RTS State Low RTS

7-23

1 2 ... 342 343 344 345 346 347 348 349 350 351 352 ... 963 964

Comentarios a estos manuales

Sin comentarios

Zebra MP6000 Información técnica Pagina 347

Comentarios a estos manuales

Relacionado con productos y manuales para Lectores De Códigos De Barras Zebra MP6000