Zebra XiII-Series Manual de usuario descargar pdf (Pagina 41)

Configuration and Calibration

After you have installed the media and ribbon and the POST (Power-On

Self Test) is complete, the front panel display will show “PRINTER

READY.” You may now set printer parameters for your application using

the front panel display and the five keys directly below it.

If it becomes necessary to restore the initial printer defaults, see “Feed Key

and Pause Key Self Test” on page 68.

NOTE: Unless otherwise noted, all parameters are listed in the order they

are displayed, starting with “DARKNESS”.

Entering the Program Mode

To enter the programming mode, press the Setup/Exit key. Press either the

Next/Save key or Previous key to scroll to the parameter you wish to set.

Parameters in this section are shown in the order displayed when pressing

the Next/Save key. Throughout this process, press the Next/Save key to

continue to the next parameter; or, press the Previous key to go back to the

previous parameter in the cycle.

An asterisk (*) in the upper left hand corner of the display indicates that the

value displayed is different than the currently stored value.

Zebra XiII-Series User’s Guide 29

H:...Xi2UsersGuideR2.vp

Fri Aug 07 10:35:48 1998

Color profile: Disabled

Composite Default screen

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 117 118

Sin comentarios

Zebra XiII-Series Manual de usuario Pagina 41