Zebra PA400 Manual de usuario descargar pdf (Pagina 14)

4. The battery charging LED will briefly flash and then stay on. When

the battery is fully charged (approximately one hour for the standard

battery; two hours for the extended life battery), the light will go off.

5. You may either remove the battery charger from the printer or leave it

connected for a continuous maintenance charge.

Loading the Media

You can operate this printer in one of two different modes: Tear-Off or

Peel-Off. Tear-Off mode allows you to tear off each label (or a strip of

labels) after it is printed. In Peel-Off mode, the backing material is peeled

away from the label as it is printed. After you remove this label, the next

one is printed.

Tear-Off Mode

NOTE: If ribbon is loaded (PT400 only), remove the ribbon

cartridge before loading the media.

1. Refer to Figure 4. Raise the media access door by lifting at the notch

until it unhooks from the top cover.

Top Cover

Notch

Media

Access

Door

Figure 4

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 57 58

Sin comentarios

Zebra PA400 Manual de usuario Pagina 14