Zebra PA400 Manual de usuario Pagina 17

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 58
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 16
9. Refer to Figure 7. If it’s not already in place, install the tear bar in the
media access door. Gently lift the tab on the bar to move it over the
protrusion on the door. Make sure the lip of the bar (inset, Figure 7)
faces out of the printer.
If you’re using direct thermal media, continue on with step 10.
However, if you’re using thermal transfer media, you must also install
a ribbon cartridge. Proceed to “Loading the Ribbon” in this chapter.
10. Close the printhead and the top cover.
8
Ta b
Lip
Protrusion
Figure 7
Vista de pagina 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 57 58

Comentarios a estos manuales

Sin comentarios