Zebra R-2844Z Guía de usuario descargar pdf (Pagina 25)

Parallel Interface Requirements

The required cable (IEEE 1284-compliant is recommended) must have a

standard 36-pin parallel connector on one end, which is plugged into the

parallel port located on the back of the printer. The other end of the parallel

interface cable connects to the printer connector at the host computer.

For pinout information, refer to page 72.

Ethernet Interface Requirements

Ethernet provides a powerful networking capability that can be of use in a

variety of internet/intranet printing solutions. After you load media and

close the top cover, you can press the test button next to the connector on

the rear of the printer to get an ethernet configuration label.

Serial Interface Requirements

The required cable must have a nine-pin “D” type (DB-9P) male connector

on one end, which is plugged into the mating (DB-9S) serial port located on

the back of the printer. The other end of this signal interface cable connects

to a serial port at the host computer. Depending on the specific interface

requirements, this will most likely be a null modem cable.

For pinout information, refer to page 74

980476-001A 17

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 85 86

Sin comentarios

Zebra R-2844Z Guía de usuario Pagina 25