Zebra Stripe Guía de usuario descargar pdf (Pagina 57)

Operations

Load Ribbon

6/15/09 S4M User Guide 13290L-004 Rev. A

Remove Used Ribbon

Remove used ribbon from the ribbon take-up spindle each time you change the roll of ribbon

or when switching from thermal transfer mode to direct thermal mode.

To remove used ribbon, complete these steps:

To loosen the ribbon, squeeze it against the ribbon take-up spindle tension blades (1). At

the same time, turn the ribbon take-up spindle release knob counterclockwise (

2).

The tension blades collapse into the ribbon take-up spindle, loosening the ribbon.

3. Slide the used ribbon off of the ribbon take-up spindle and discard.

Caution • Do not cut the ribbon directly on the ribbon take-up spindle. Doing so may

damage the spindle.

If the ribbon has not run out, cut or break it before the ribbon take-up spindle (1).

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 149 150

Sin comentarios

Zebra Stripe Guía de usuario Pagina 57