Zebra ZP 450 Guía de usuario descargar pdf (Pagina 33)

Operations & Options

Printing in Dispenser Mode

12/17/07 ZP 450™ User Guide 980546-003 B

Printing in Dispenser Mode

The factory installed label dispenser option allows you to print a label with backing (liner/

web) being removed from the label as it prints, ready for application. When printing multiple

labels, removing the dispensed (peeled) label notifies the printer to print and dispense the next

label.

To use dispenser-mode correctly, use your printer driver to activate the label (taken) sensor

along with these typical label settings which include but are not limited to length, non-

continuous (gap), and web (liner). Otherwise, you must send the ZPL or EPL programming

commands to the printer.

When programming in ZPL, you can use the following command sequences shown below

and refer to your ZPL Programming Guide for more information on ZPL programming.

^XA ^MMP ^XZ

^XA ^JUS ^XZ

When programming in EPL, send the Options (O) command with the ‘P’ command

parameter (

OP) to enable the Label Taken sensor. Other printer option parameters may also be

included with the Options command string. Refer to your EPL Programmer’s Guide for more

information on programming with EPL and the Options (

O) command behaviors.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 69 70

Sin comentarios

Zebra ZP 450 Guía de usuario Pagina 33