Zebra QL320 Plus Guía de usuario descargar pdf (Pagina 10)

Introduction

Getting Started

Using the

Printer

Troubleshooting

Accessories

QL Plus Series

Quick Start Guide

Fault

Fast Charge

Fault

Fast Charge

Fault

Fast Charge

Ready

Power

Full Charge

Ready

Full Charge

Ready

Full Charge

Fault

Fast Charge

Ready

LI72-4 Quad Charger

Accessories

The UCLI72-4 Quad Charger is designed to charge up to four QL

series battery packs simultaneously.

Plug a battery pack into any one of the four charging bays as

shown opposite, noting the orientation of the battery pack. Slide

the battery pack into the charging bay until it stops. Then rock the

battery pack back until it snaps into place. The amber indicator di-

rectly under the battery being charged will turn on if the battery is

properly inserted.

The indicators under the battery will allow you to monitor the

charging process per the table below:

Amber Green

Battery Status

On Off Charging

On Flashing

80% charged

(O.K. to use)

Off On

Completely

Charged

Flashing Off Fault

Notes: For more information refer to the instructions included

with the LI72-4 Quad Charger, or to the more detailed discussion

of the quad charger in the QL Plus User Guide.

The UCLI72-4 Quad Charger has a safety feature which stops

charging a battery after six hours regardless of its charge state.

Belt Clip (standard on all printers)

To use: hook the clip over your belt,

and ensure that the clip is securely

attached to the belt. The belt clip

will pivot in all directions to allow

you to move freely while wearing the

printer.

Section Continues

Charger Bay

Amber

Indicator

Green

Indicator

Power Indicator

Power Supply

1. Slide Battery Pack

into a Charger bay

2. Rock Battery

Pack into place

Printer can pivot

freely

Clip printer to

belt

1 2 ... 5 6 7 8 9 10 11 12

QL Plus Series 1
Quick Start Guide 1

Comentarios a estos manuales

Sin comentarios

Zebra QL320 Plus Guía de usuario Pagina 10

Comentarios a estos manuales