Zebra Q3DLUBA000002 Manual de usuario descargar pdf (Pagina 24)

• 2-47 • RMAN-QLS-002 rev. A Repair Procedures

the QL 320.

Important note for QL 320 units built before 1/20/03. Use of Media Cover Replacement Kit

AN16861-023 requires the use of the Platen and Gear Assemblies included in Replacement Kits AN16861-

035 (linered) and -036 (linerless). You will not be able to use the original Platen and Gear Assemblies sup-

plied with the printer.

Refer to the platen replacement Procedures for AN16861-013 or -014 for QL 320 units built after 1/20/03.

6b. If necessary, replace the Media Guide Rollers (AN 16753-003 or -004) and the

Platen, Gear and the Peeler Bar or Scraper on the QL 420

(Refer to Procedures for AN16753-021 or -022)

7. Install the Upper Housing.

8. Install the QuickLink module.

9. Calibrate the Sensors.

This procedure can only be performed by Zebra certiﬁed personnel using special equip-

ment and software.

Using the gray and white swatches, follow the on-screen instructions on the unit

test and set-up software to properly calibrate the sensors. It is recommended

that the complete unit test procedure be performed.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 108 109

Sin comentarios

Zebra Q3DLUBA000002 Manual de usuario Pagina 24