Zebra KR403 Especificaciones descargar pdf (Pagina 39)

Setting Printer Behaviors

Printer Settings - Options Tab

10/29/2010 Software Integrator Guide P1026208-001 Rev. B

Once the printer has been set to Black Mark/Line media mode (^MNM), the printer

needs to be calibrated to the black mark/line media installed in the printer. Use the

Action-Calibrate Media Tools selection and Send. The printer will now measure

the media.

• If you are using the printer in one of the two non-kiosk modes, Rewind

(^MMR) or Cutter (^MMC) Modes, then the printer needs to be re-configured.

Use the Action - Send Command Tools selection to Send the printer one of the

following command lines (a printer configuration format):

Cutter

^XA^MMC^JUS^XZ

Rewind ^XA^MMR^JUS^XZ

Printer Settings - Options Tab

This tab in the driver controls the label’s print area, including print speed and darkness

settings. Equivalent ZPL commands are shown on the left and described below.

Figure 4-2 • Printer Properties - Options

Command Name Description

^PQ

Print Quantity Controls number of receipts to be printed

^PR

Print Rate Sets the print speed - Default 152.4mm/s

(max.)

~SD

Set Darkness Sets darkness - Default 20 for kiosk printers

^MU

Set Units of Measure Sets Dots (default), Inch, Millimeters for ZPL

^PQ

^PR

~SD

^PO

^PW

^LL

^LX

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 157 158

Sin comentarios

Zebra KR403 Especificaciones Pagina 39