Zebra TTPM2 Manual de usuario descargar pdf (Pagina 4)

and 57600 bps in addition to the default speed 9600 bps.

•

To enhance ticket handling speed, front load printers read track 2 data to

memory when loading the ticket. Previously, a separate read movement

was required when !D command read data to host computer.

•

Support for Dallas 80C320 microprocessor (on control board) introduced.

906-280

Bug fixes

•

This firmware version now supports both the old 80C32 processor, an

enhanced ("incompatible") 80C32 processor, and the enhanced 80C320

microprocessor.

•

An erroneous encoding with the !N command now results in NAK + F

(15H + 46H).

Restrictions

•

It is not possible to read track No. 2 on 110 mm long tickets inserted

through the optional front load mechanism.

•

Specifying text, graphics or bar code printing outside the valid co-

ordinates makes the processor enter a loop with strange behavior of

lamps, paper feed and cutting motors. Fortunately, you will discover this

problem already during the design and testing of the application software.

To recover from the error situation, clean the TTPM2 from any remaining

paper particles and perform a "warm start" by holding all three operator

control push buttons pressed while you power ON the unit.

•

Transmission rate 9600 baud is always used even if 19200 or 57600 baud

is selected.

906-290

Bug fixes

•

Transmission speed 19200 baud can now be selected.

Restrictions

•

Transmission rate 57600 baud cannot be selected.

•

It is not possible to read track No. 2 on 110 mm long tickets inserted

through the optional front load mechanism.

•

Specifying text, graphics or bar code printing outside the valid

coordinates makes the processor enter a loop with strange behavior of

lamps, paper feed and cutting motors. Fortunately, you will discover this

problem already during the design and testing of the application software.

To recover from the error situation, clean the TTPM2 from any remaining

paper particles and perform a "warm start" by holding all three operator

control push buttons pressed while you power ON the unit.

906-300

Bug fixes

•

Problems with long, thick tickets not loading and cutting correctly solved.

•

Icelandic characters added.

Restrictions

•

Same as 906-290.

3.20

Added functions

Added commands !Q, !U, !V, and !N+.

New magnetic encodi

ng attributes added

1 2 3 4 5 6

Comentarios a estos manuales

Sin comentarios