Zebra II Especificaciones descargar pdf (Pagina 105)

^CW

Font Identifier

Description: All built-in fonts have a one-character identifier. The ^CW command

assigns a single alphanumeric character (A through Z and 0 to 9) to a font stored in

DRAM, memory card, EPROM or Flash.

If the assigned character is the same as that of a built-in font, the downloaded font is

used in place of the built-in font. The new font will be printed on the label wherever

the format calls for the built-in font. If used in place of a built-in font, the change is

only in effect until power is turned off.

If the assigned character is different, the downloaded font is used as an additional

font. The assignment will remain in effect until a new command is issued or the

printer turned off.

Format: ^CWa,d:o.x

Parameters:

a = letter of existing font to be substituted, or new font to be added

Required is a one-character entry.

d = destination of device to store font in (optional)

Accepted Values: E:, B:, R:, Z:

Default: R:

o = name of the downloaded font to be substituted for the built-in, or

as an additional font (1 to 8 alphanumeric characters)

Accepted Values: any name up to 8 characters

Default: If no name is entered, UNKNOWN is used.

x = 3-character extension

Fixed: .FNT

ZPL II Programming Guide Volume One: Command Reference for X.10

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 261 262

Sin comentarios

Zebra II Especificaciones Pagina 105