Zebra 105SL Especificaciones descargar pdf (Pagina 21)

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 1-9

DESCRIPTION OF EQUIPMENT SECTION 1

on the information from the transmissive media sensor pair but starts based on information

from another pair of media sensors, the take label or label available sensor pair.

7DNH/DEHO6HQVRUV

See Figure 1-5. This pair of sensors detects the absence of a label printed on non-continuous

media in the peel off mode. When the label is removed, the sensor pair signals the processor

and the processor starts printing the next label.

5LEERQ6HQVRU

See Figure 1-6. This sensor detects the absence of ribbon and sends a “ribbon out” message

to the processor. The processor pauses the printing until more ribbon is loaded.

Figure 1-5. Take Label Sensor Pair

Figure 1-6. Ribbon Sensor, Guard Plate and Printhead

Label

Available

Sensors

Printhead Assembly

Pivot Bar

Allen Screws

Guard Plate

Allen Screw

Flat Washer

Washer

Ribbon Sensor

Split Grommet

(See Note)

Note:

Position Ribbon Sensor Tab Not

To Be Flush With Top Edge of Pivot Bar.

Gap 0.010 Min./0.030 Max. Below Top Edge.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 245 246

Sin comentarios

Zebra 105SL Especificaciones Pagina 21