Zebra 96XiIII Plus Guía de usuario descargar pdf (Pagina 171)

171

Troubleshooting

Printer Diagnostics

9/6/07 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-004 Rev. A

Communications Diagnostics Test

The communication diagnostics test is a troubleshooting tool for checking the interconnection

between the printer and the host computer.

When the printer is in diagnostics mode, it prints all data received from the host computer as

straight ASCII characters with the hex values below the ASCII text. The printer prints all

characters received, including control codes such as CR (carriage return). Figure 35 shows a

typical test label from this test.

Figure 35 • Communications Diagnostics Test Label

To use communications diagnostics mode, complete these steps:

1. Set the print width equal to or less than the label width being used for the test. See Set

Print Width on page 75 for more information.

2. Set the printer to DIAGNOSTICS. For instructions, see Set Communications Mode

on page 88.

The printer enters diagnostics mode and prints any data received from the host computer

on a test label

3. Check the test label for error codes. For any errors, check that your communication

parameters are correct.

Errors show on the test label as follows:

• FE indicates a framing error.

• OE indicates an overrun error.

• PE indicates a parity error.

• NE indicates noise.

4. Turn the printer off (O) and then back on (I) to exit this self test and return to normal

operation.

Note • The test label prints upside-down.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 229 230

Sin comentarios

Zebra 96XiIII Plus Guía de usuario Pagina 171