Zebra Z6Mplus Guía de usuario descargar pdf (Pagina 99)

Configuration

Control Panel LCD Displays

1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A

Select Head Close Option

This parameter sets the action of the media when you close the printhead.

Default: CALIBRATION

Selections: FEED, CALIBRATION, LENGTH, and NO MOTION

• Feed—feeds the labels to the first registration point.

• Calibration—determines the length of the label and adjusts the

sensor settings.

• Length—In continuous mode, feeds the last stored label length. In

noncontinuous mode, calibrates based on the maximum label length

setting (see Set Maximum Label Length on page 78).

• Short Cal—calibrates label length using the current sensor settings.

• No Motion—the media does not move. You must press

FEED to

cause the printer to resynch to the start of the next label.

To change the value shown:

1. Press SELECT to select the parameter.

2. Press

PLUS (+) or MINUS (-) to scroll through the options.

3. Press

SELECT to accept any changes and deselect the parameter.

Select Backfeed Sequence

This parameter sets when label backfeed occurs after a label is removed in

some print modes. It has no effect in Rewind mode. This setting is

superseded by

~JS when received as part of a label format (see ZPL II

Programming Guide Volume I).

Default: DEFAULT (90%)

Selections: DEFAULT, AFTER, BEFORE, 10%, 20%, 30%, 40%, 50%,

60%, 70%, 80%, OFF

To change the value shown:

1. Press SELECT to select the parameter.

2. Press PLUS (+) or MINUS (-) to scroll through the options.

3. Press

SELECT to accept any changes and deselect the parameter.

Table 9 • Printer Parameters (Page 19 of 23)

Parameter

Action/Explanation

HEAD CLOSE

- CALIBRATION +

BACKFEED

- DEFAULT +

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 165 166

Comentarios a estos manuales

Sin comentarios

Zebra Z6Mplus Guía de usuario Pagina 99

Comentarios a estos manuales

Relacionado con productos y manuales para Impresoras De Etiquetas Zebra Z6Mplus