Zebra S600 Especificaciones descargar pdf (Pagina 130)

Page 4-56 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

6WHSSHU0RWRU5HSODFHPHQW

1. Turn the printer Off (O), and remove the AC power cord and data cable.

2. Remove media and ribbon.

3. Remove the main door and rear cover.

4. Remove the main logic board.

5. Remove the main drive belt.

6. Refer to Figure 4-48. Remove the screw, underneath the upper media guide

assembly, holding the stepper motor to the main frame.

7. Refer to Figure 4-49 on page 4-57. Disconnect the stepper motor cable (J1) from

the power supply board.

8. Carefully grasping the stepper motor, turn it counterclockwise and remove it from

the slots.

9. Reverse steps 6 through 8 to install the replacement stepper motor.

10. Replace the main drive belt and adjust the tension.

11. Replace the main logic board.

12. Replace the rear cover and main door.

13. Reload media and ribbon.

14. Reconnect the AC power cord and data cable. Turn the printer On (l), and test for

proper operation.

Figure 4-48. Stepper Motor (Media Side)

OPEN

Upper Media

Guide Assembly

Printhead

Assembly

Stepper Motor

Mounting Screw

Stepper Motor

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 167 168

Sin comentarios

Zebra S600 Especificaciones Pagina 130