Zebra S600 Especificaciones descargar pdf (Pagina 82)

Page 4-8 S400/S600 Maintenance Manual 44895L Rev. 3 3/15/04

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

3ULQWKHDGDQG3ODWHQ5ROOHU&OHDQLQJ3URFHGXUH

1. Refer to Figure 4-1. Open the main door and front door.

2. Open the printhead by turning the locking lever counterclockwise.

3. Remove the media and ribbon if present.

4. Refer to Figure 4-2 on page 4-9. Use a cleaning swab to wipe the print elements

from end to end. Allow a few seconds for the solution to evaporate.

5. Rotate the platen roller and clean thoroughly with a cleaning swab.

6. Brush or vacuum any accumulated paper, lint, and dust away from all of the rollers

and the media and ribbon sensors.

7. Reload the ribbon and/or media. Close and latch the printhead. Close the main and

front doors, and restore power (if previously turned off).

8. Run the Pause Key Self Test to check print quality.

Figure 4-1. Main Door and Front Door

Main Door

Front Door

Tab

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 167 168

Sin comentarios

Zebra S600 Especificaciones Pagina 82