Zebra TTP2130 Especificaciones descargar pdf (Pagina 62)

Programming

Software command syntax

P1003640-001 TTP2100 Technical Manual 10/22/2008

The value n represents the number of dot lines the paper is to be transported backwards.

Range: 1–255.

A dot line is 0.125 mm, and 255 dot lines equal approximately 32 mm.

The value n1 n2 represents high byte and low byte of the number of dot lines the paper is to be

transported forwards. Minimum value is 0, and maximum value is 32767.

A dot line is 0.125 mm, and 32767 equals approximately 4.1 m.

Cut and Present Commands

Effects a paper cut-off and an eject through the presenter module. The RS command

automatically give the eject length of 50 mm in addition to the factor stored in parameter p47.

If the printout length is too short, paper-feed is added until the minimum printout length (set by

parameters 37 and 38) is reached, before execution of the Cut command.

If you do not use the auto setting you can use <RS> together with the paper advance

command:

Gives a cut & eject after

the last text line.

ESC j n1

Paper Reverse

1B 6A n1 hex

27 106 n1 decimal

Caution • NEVER reverse more than 6 mm at top of page! You may lose grip of the paper.

ESC Q n1 n2

Quick Advance

1B 51 n1 hex

1B 81 n1 Decimal

Note • The printer does not receive data while cut and present commands are executed.



Cut and Eject

1E Hex

30 Decimal

Note • The cut position is 9 mm before the print line. This makes the last 2 lines on a page

end up in the beginning of the next page. To get the cut after the text, Please have parameter

49 set to auto (default setting).

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 137 138

Sin comentarios

Zebra TTP2130 Especificaciones Pagina 62