Zebra RW 420 Guía de usuario descargar pdf (Pagina 13)

RW Series User Guide

Installing RW Series Batteries

Important • Batteries are shipped uncharged. Remove protective

shrink-wrap and labels from new battery packs prior to use.

1. Rotate the Belt Clip to allow access to the Battery com-

partment. This is an optional step on the RW 220.

2. Insert the battery into the printer as shown in Figure 3 or

3. Rock the Battery into the printer as shown until it locks in

place.

When the battery is ﬁrst installed, the Control Panel indica-

tors may brieﬂy turn on and then go off, indicating the battery

is not fully charged (see “Charging the Battery” below and

“Operator Controls.”)

Charging the Battery

The LI72 is a wall mounted fast charger with universal 110

to 230, 50-60 Hz. VAC input. Multiple A.C. plug conﬁgurations

comply with most international standards. This charger is in-

tended for use with the RW series printers which are equipped

with Lithium Ion (Li-Ion) batteries.

continued

Figure 5: LI 72 Single Charger

LI72 Charger

For best results,

remove the

Battery Pack while

charging.

Charger Jack

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 83 84

Sin comentarios

Zebra RW 420 Guía de usuario Pagina 13