Zebra SAP Smart Forms and Zeberea Print Manual de usuario descargar pdf (Pagina 48)

Basic Smart Form Design

Smart Styles—Planning for Smart Forms

13760L-001 Rev. A Zebra Printers and SAP® Smart Forms™ Solution Guide 12/27/10

Smart Styles—Planning for Smart Forms

Before starting to lay out your form, you must determine which text and bar code objects you

will require. You actually need to build a collection of all of the derivatives of text and bar

codes you will use within the Smart Form. All of these objects need to be created and collected

within a Smart Style.

Bar codes are more complex, as you need to create the specific bar code derivatives that you

will need; this is done with transaction /nSE73.

Text is relatively simple and does not normally require any additional management other than

within Smart Styles.

The following procedure will create a Smart Style that uses the Font “HELVE” 12 point and 24

point. You will also use a Code 39 bar code with a height of 20 mm and a narrow bar width

0.25 mm (2 dots on a 203-dpi/8-dpm printer).

Create the Bar Codes You Need

To create bar codes, perform the following:

1. Execute Transaction /nSE73.

Figure 33 opens.

Important • Before proceeding, Zebra strongly recommends that you read the chapter

entitled Advanced Form Design on page 79.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 95 96

Sin comentarios

Zebra SAP Smart Forms and Zeberea Print Manual de usuario Pagina 48