Zebra T5206R Manual de usuario descargar pdf (Pagina 337)

Fault Messages

337

PAPER OUT

TIMEOUT

Yes In the CT emulation

with a coax interface, a

time-out message is

sent to the host if paper

is not loaded within 10

minutes after PAUSE

was pressed to clear a

paper out fault.

Load media and run a print

test. If the message persists,

contact your authorized service

representative.

PARITY ERROR Yes Parity error (serial

interface).

Check your serial host

interface parameter settings. If

necessary, change them so

they match the settings of the

attached host.

POOR SCANNING

Check Head&Heat

Yes Data validation failure:

The ratio between bar

code elements is too

small.

Adjust heat/speed/pressure.

POOR SCANNING

Check media

Yes Data validation failure:

The bar code is only

good in small bands

that are difficult to

scan.

Check for ribbon wrinkle. Roll

wrinkled area onto take-up

spindle.

POOR SCANNING

Inspect head

Yes/No Data validation failure:

Defects failure;

blemishes with the bar

code are detected.

1. Check paper and ribbon to

make sure they are clean,

unwrinkled, and installed

properly.

2. Clean printhead.

3. If message persists,

replace the printhead.

POWER SAVER

MODE

Yes This is a status

message. The printer

is in low-energy idle

state, the fan and

higher voltages are off,

and only +5Vdc logic

circuits are active.

No action required.

Table 17. LCD Message Troubleshooting (continued)

Displayed Message

Can User

Correct?

Explanation Solution

1 2 ... 332 333 334 335 336 337 338 339 340 341 342 ... 393 394

Comentarios a estos manuales

Sin comentarios