Zebra T5206R Manual de usuario descargar pdf (Pagina 365)

Restore The Printer To Operation

365

Restore The Printer To Operation

NOTE: The printer cannot detect the presence of the cutter unless the cutter

is in the up (closed) position and the cutter top cover is installed when

the printer is powered on.

1. Set the printer power switch to | (ON).

2. Press to place the printer in Menu Mode.

3. Press the ↓ and ↵ keys at the same time until “ENTER SWITCH

UNLOCKED” appears on the printer display.

4. Press until “MEDIA CONTROL” displays.

5. Press ↓ until “Media Handling” displays.

6. Press + or - until the “Cut” option displays.

7. Press ↵ to select “Cut.” An asterisk (*) displays next to “Cut.”

8. Relock the ↵ key by pressing ↓ and ↵ at the same time, then press

PAUSE to put the printer back online.

9. If the bar code validator is installed, adjust the validator beam.

(See the Online Data Validator User’s Manual).

10. Make sure any media sticking out of the platen goes in the cutter entrance

slot.

11. Test the printer cutting operation and print quality by selecting the

Diagnostics → Printer Tests menu and printing one of the test patterns.

(Refer to “DIAGNOSTICS” on page 237.)

12. To save the configuration parameters, refer to “Saving A Configuration”

on page 88.

Removing The Media Cutter

1. Set the printer power to O (OFF).

2. Pull the cutter assembly to the down (open) position.

3. Using the appropriate metric hex key, remove the two screws securing

the cutter bracket to the lower support assembly.

4. Unplug the RJ-11 connector from the RJ-11 receptacle.

5. Remove the media cutter from the printer.

6. Install the front door assembly on the printer lower support assembly.

1 2 ... 360 361 362 363 364 365 366 367 368 369 370 ... 393 394

Sin comentarios

Zebra T5206R Manual de usuario Pagina 365