Zebra TTPM3 Especificaciones descargar pdf (Pagina 100)

Specifications

Document Stock

P1003642-001 TTPM3 Installation and Programming Manual 01/06/2009

Document Stock

The TTPM3 printers are produced and calibrated for, and tested with the customer’s ticket

stock. To ensure accurate ticket issuing, we do require 100 tickets of the customer ticket stock

for each ordered printer.

Ticket Base Material

Type of paper Ricoh 150UT 240µ, Mitsubishi TF 2475, and Tyco Sharkskin are

recommended. See

http://www.zebra.com for current

recommendation.

Material Paper, 100 % chemical pulp, no ground wood permitted

Triplex* laminate**

Plastic (polypropylene Sharkskin

)

*. Triplex is manufactured from three paper stocks. The middle is usually recycled paper, and the top and bottom are

different papers.

**. Laminate with plastic core may destroy the printhead and prematurely wear out the cutter blades! DO NOT

USE.

The perforation of the tickets may leave parts of the plastic core protruding through the surface of the ticket.

These plastic tongues may scratch the printhead, and also build up static electricity discharging through the

printhead. This may seriously limit the printhead life.

If plastic laminate still is used, care must be taken in the manufacturing process to avoid the plastic protrusion, and

the printer must be life-tested with the intended stock before taken into use.

Stiffness 18–36 g/cm (in grain direction)

Thickness Paper and laminate: 0.18–0.40*** mm, 170–210 g/m²

Plastic (polypropylene Sharkskin

): 0.18–0.25 mm

Factory setting: Set to the customer’s tickets. A minimum of 100

tickets per printer ordered must be sent to Zebra when ordering

printers.

***. 0.18-0.32 mm for Frontload 1 and Frontload 2 versions of the printer

Curl Deviation from flatness < 0.6 mm across the length, width, or

diagonal of the ticket

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 111 112

Sin comentarios

Zebra TTPM3 Especificaciones Pagina 100