Zebra TTPM3 Especificaciones descargar pdf (Pagina 44)

Programming

Command Reference

P1003642-001 TTPM3 Installation and Programming Manual 01/06/2009

The burn time controls the print density. It is used to set the heating so that it is adequate for

the thermal paper used as ticket material. Set it to the lowest burn time that gives acceptable

print quality.

The burn time setting is stored in the non-volatile memory.

Power off/on reset returns the setting to default value.

The TTPM3 responds by sending the same 1 byte response to the host computer as is sent as

byte 1 in response to the !S command. The ENQ command is effected immediately after

receipt, whereas the !S command is effected in sequence when received.

Set burn time

21 5A Hex

33 90 Decimal

Setting Burn time Print Density

16 512 μs Lightest print

17 544 μs ↓

18 576 μs ↓

19 608 μs ↓

20 640 μsDefault

21 672 μs ↓

22 704 μs ↓

23 736 μs ↓

24 768 μs ↓

25 800 μs ↓

26 832 μs ↓

27 864 μs ↓

28 896 μs ↓

29 928 μs ↓

30 960 μs ↓

31 992 μs Darkest print

Example • This example sets the burn time to 640 μs.

!Z 20 <CR><LF>

Caution • A longer burn time puts more load on the printhead, so do not use a longer burn

time than required for a clearly legible print. Settings over 27 are not recommended.

ENQ

Status request, immediate

05 Hex

05 Decimal

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 111 112

Sin comentarios

Zebra TTPM3 Especificaciones Pagina 44