Zebra TTPM3 Especificaciones Pagina 48

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 112
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 47
Programming
Command Reference
47
P1003642-001 TTPM3 Installation and Programming Manual 01/06/2009
Only for printers with front load: Reads the ticket from the front load and immediately ejects it
back out without transporting the ticket to the active position. This command can be used to
read tickets in a printer that is configured for two consecutive tracks (where the normal !L3
command would push out the ticket from the upper entry to make place for the ticket from the
frontload).
Same function as !L1, but when ticket loading fails the printer sends an error code (NAK + '1')
instead of waiting for paper to be loaded. It is then up to the system to determine if paper
should be loaded from the upper document entry instead.
Same function as
!L2, but when ticket loading fails the printer sends an error code (NAK + '1').
It is then up to the system to determine if paper should be loaded from the lower document
entry instead.
!T@nn
nn is the delay in seconds
When a ticket is left in the output of the front load after the timeout nn has expired, NAK F is
sent to the host controller to indicate that the ticket hasn't been picked up.
If the customer takes the ticket before the timeout elapses, the printer sends a Bel (07H)
character.
@ Expands the signaling: If you have a Front load with waste basket function, the printer
retracts the uncollected ticket and ejects it into the wastebasket exit.
!L 6
Read ticket from front load
21 4C 36 Hex
33 76 54 Decimal
!L 17
Select lower rear document entry and signal if paper is out
(only dual entry printers)
21 4C 31 37 Hex
33 76 49 55 Decimal
!L 18
Select upper rear document entry and signal if paper is out
(only dual entry printers)
21 4C 31 38 Hex
33 76 49 56 Decimal
!T
Sets timeout for retract function (only printers w. waste bin)
21 54 n1...n2 Hex
33 84 n1...n2 Decimal
Note •
The !T command should be sent after the !P (print) command.
DIP-switch 6 must be ON for status replies to be sent.
Example •
!P
!T @20
Retracts the ticket and sends NAK F if it has not been taken within 20 seconds
Vista de pagina 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 111 112

Comentarios a estos manuales

Sin comentarios