Zebra ZM400 Guía de usuario descargar pdf (Pagina 32)

Getting Started

Assigning an IP Address with DHCP

47619L-006 Rev. A ZebraNet

10/100 Print Server User Guide 02/01/2011

Assigning an IP address via a Telnet session

The methods used for assigning an IP address with a Telnet session are Static Route and

Gleaning.

Before you can Telnet to the 10/100 PS and configure it, you must first assign the 10/100 PS a

temporary IP address.

Static Route

To use this method, complete these steps:

1. Turn on (I) the printer and wait for 2 minutes to allow for the device to complete the

self-test.

During this time, the 10/100 PS performs an address broadcast. If no address is assigned

to the unit (via DHCP or BootP), it uses a default address. The default address for

10/100 PS is 192.168.254.254. Print the 10/100 PS configuration label to confirm

the address. For details, see Before You Begin on page 28.

2. You can use the route add command to place the default IP address into the

workstation's network routing table.

3. At the workstation/host command prompt (in Windows, at the DOS prompt), type:

route add **** "IP address of the workstation" 0

where **** is the IP address on the 10/100 PS configuration label

4. Telnet to the 10/100 PS by typing:

"Telnet xxx.xxx.xxx.xxx"

The password is 1234.

5. At this point, you can alter the settings as desired. When complete, do a reset and allow

the 10/100 PS self-test to complete before proceeding with any communications activity.

Important • This applies to any TCP/IP capable workstation/host networked with the Zebra

printer. Both, the workstation/host and the 10/100 PS, must be on the same network segment.

Note • The zero (0) placed at the end of the “route add” command is optional on some

systems.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 115 116

Sin comentarios

Zebra ZM400 Guía de usuario Pagina 32