Zebra ZM400 Guía de usuario descargar pdf (Pagina 47)

Getting Started

Defaulting the 10/100 PS

02/01/2011 ZebraNet

10/100 Print Server User Guide 47619L-006 Rev. A

Using ZebraNet Bridge

ZebraNet Bridge may be used default the 10/100 PS to factory settings. Refer to the ZebraNet

Bridge Enterprise User Guide for more detailed information.

Using the Test Button

To default the 10/100 PS to factory settings using the Test button, complete

these steps:

The Test button is accessed via a small recessed hole on the back of the external 10/100 PS

device (see Figure 3 on page 23). For the internal 10/100 PS device, the

Test button is located

on the back of printer. To press the

Test button, you need to insert something small into the

hole, like the end of a paperclip.

1. Turn off (O) the printer.

2. With the printer turned off (l), press and hold the Test button on the 10/100 PS device and

turn on the printer.

3. The status indicator tells you when 10/100 PS has been reset to factory defaults, as

follows:

• If an active network cable is connected to the 10/100 PS, the status indicator turns

solid green. When this happens, you can release the

Test button.

• If there is not an active network cable connected to the 10/100 PS, the status indicator

flashes red. When this happens, you can release the

Test button.

• For more details on status indicators, see 10/100 PS Network Status/Activity Indicator

on page 99.

Note • You must have an active network cable connected to the 10/100 PS device to

default the device using the

Test button.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 115 116

Sin comentarios

Zebra ZM400 Guía de usuario Pagina 47