Zebra KR403 Especificaciones descargar pdf (Pagina 24)

Introduction

Installing the Media Guide (Required Accessory)

P1016701-001 KR403 Integrators Guide 12/23/2009

2. Select the media guide that matches the width of the media you want to use for your

application. Loosen or remove the media guide screw, if present.

3. Open the printhead by pushing green printhead release push-bar back towards the rear of

the printer and lift up the printhead.

4. Insert the media guide under the printhead. Insert the T-shaped tab of the media guide into

the “T”-hole, slide it forward, and fasten the screw. The screw is pre-installed at the

factory on the printer. One is included in the bag with the media guide in case the screw is

damaged or lost. Many times, the installer will only need to loosen the attached screw.

5. Close the printhead. Push down on the push-bar to securely latch the printhead closed.

6. Re attach the printer’s power if needed.

Note • Media guides are ordered separately. Only Printer Evaluation kits contain all input

guides available for the KR403.

Media Guide Screw

M2.5 x 3

Media Guide Width

in Millimeters (mm)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 119 120

Sin comentarios

Zebra KR403 Especificaciones Pagina 24