Zebra KR403 Especificaciones descargar pdf (Pagina 48)

Operation

Preparing a Media Roll for Use

P1016701-001 KR403 Integrators Guide 12/23/2009

3. The loading process works best with the cut as a square, straight edge. Cut the paper in a

suitable angle.

If the media is not cut square and the operator does not have the ability to cut or tear a

straight edge, then the printer can fail to load the media or even cause a media jam. The

media should not make contact with the platen roller before the sensor detects the media.

The distance between the platen roller and media sensor is approximately 10 mm (0.39

inches).

Figure 1 • Suitable Paper Edge for Auto Load

Important • The wide media sensor (88 and 82.5 mm) and printer's power connector are both

located on the right side of the printer when looking into the printer from the rear. The media

sensor for narrow media (58 and 60 mm) is located on the left side when looking into the

media input slot from the rear of the printer.

Auto Loads

Wide Media

Auto Loads

Narrow Media

Auto Loads

Fails Auto Load

Media Contact

Leads

Media Sensing

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 119 120

Sin comentarios

Zebra KR403 Especificaciones Pagina 48