Zebra KR403 Especificaciones descargar pdf (Pagina 69)

Printer Maintenance

On-Site Service Cleaning

12/23/2009 KR403 Integrators Guide P1016701-001

On-Site Service Cleaning

The KR403 printer may require a periodic deep cleaning to remove accumulated debris that

can build-up on the media path, sensors and rollers. Normally this type of cleaning will rarely

need to be done if the operator does the Dust Removal Cleaning regularly.

Labels and some non Zebra media can increase the need for cleaning. Labels can slowly

transfer adhesive from the edges of the label to the media path (and printhead). Poor quality

label media can excess adhesive. Some direct thermal receipt media can have chemicals that

can harm your printhead or cause the dust and particles to stick to the media path.

Some kiosk installation environments have chemicals, grease (cooking), tobacco smoke, etc.

that can accumulate in the printers media path and sensors.

You may need to remove the printer from the kiosk to perform to gain access to all sides of the

printer.

1. Start by doing the Dust Removal Cleaning (Dust Removal Cleaning on page 56) to reduce

the accumulated contaminates in the printer. Leave the media guide off and do not clean

the printhead until the end of this procedure.

2. Remove the Present Feed Roller Assembly. Push the retaining tab on either side and lift

the roller assembly up out of the printer. Rotate and clean the rollers, and the rest of the

assembly. Set the assembly aside.

Caution • Always disable printer power by un-plugging the printer from the kiosk power

supply or turning off the printer and/or kiosk power.

Push Tab Here

and Lift

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 119 120

Sin comentarios

Zebra KR403 Especificaciones Pagina 69