Zebra KR403 Especificaciones descargar pdf (Pagina 67)

Printer Maintenance

Operator Maintenance

12/23/2009 KR403 Integrators Guide P1016701-001

Use a can of compressed air to remove dust and particle build-up from the printer.

1. Spray the dust off the outside of the printer.

2. If you have access to the media output slot on the bottom of the printer, then spray the

Waste Bin sensor and through out the media output slot.

3. Open the printhead and remove the media guide plate (see Installing the Media Guide

(Required Accessory) on page 13).

4. Spray the media input area, platen (drive) roller, and then each of the three media sensors

and the head-up sensor.

5. Replace the media guide plate, clean the printhead (see Cleaning the Printhead

on page 42), and then close the printhead.

Waste Bin

(media)

Sensor

Media Sensors Head-up Sensor

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 119 120

Sin comentarios

Zebra KR403 Especificaciones Pagina 67