Zebra RW SERIES Especificaciones descargar pdf (Pagina 88)

RMAN-RWS-001 rev. B • RW Series Repair Procedures • 2-88 •

5. Reassemble the radio PCB assembly to the Bracket, Radio.

6. Plug the Keypad ex circuit from the Keypad and Housing into J7 on the CPU

board. Plug the LCD ex circuit from the Keypad and Housing into J9 on the

CPU board. Ensure both connector’s locking tabs are secured.

7. Rotate the Keypad and Housing assembly onto the lower housing of the printer.

Ensure that you tuck the LCD and Keypad Flex circuits behind the edge of the CPU

Board before securing the two housings.

Align the two housings and press the Keypad and Housing rmly into place.

Secure the housings together with the (6) screws you retained when removing

the old Keypad and Housing.

8. Re-assemble either the “D” rings or the carrying strap between the upper and

lower housings before securing the two housings with the long screws. Refer

to the procedure for RK17393-023 for more details.

7. If appropriate, you may install the Product ID label supplied with the kit in the

recess on the top of the new Keypad and Housing.

Radio PCB Assembly

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 113 114

Sin comentarios

Zebra RW SERIES Especificaciones Pagina 88