Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 11)

Media & Ribbon Loading

If you have a right hand print engine (printed labels are presented on the right hand side

of the unit), refer to Figure 2 while performing the procedure shown below. If you have

a left hand unit (printed labels are presented on the left hand side of the unit), refer to

Figure 3 on page 10.

1. Load the media on the media supply reel of the applicator (refer to the applicator’s

user’s manual).

2. Grasp the thumb nut (A) and slide the outer media edge guide (B) as far out from

the print engine frame as possible. (The thumb nut does not have to be loosened.)

3. Open the printhead assembly (C) by unlatching the printhead lock lever (D) from

the locking pin (E).

4. Raise the pinch roller (F) by pressing down on the pinch roller assembly latch (G).

Thread the media under the upper guide post (H), between the pinch roller and the

associated rubber pinch roller, and under the printhead assembly (C) until approxi-

mately 30" (75 cm) of media extends out of the print engine.

Figure 2. Media Loading (Right-Hand Units)

OPEN

MEDIA

PATH

MEDIA

BACKING

LABEL

SEE DETAIL

OPEN

DETAIL

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 11