Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 31)

100

CALIBRATING

PLEASE WAIT

The print engine automatically adjusts the scale (gain) of the signals it receives

from the media and ribbon sensors based on the specific media and ribbon com-

bination you are using. On the sensor profile, this essentially corresponds to

moving the graph up or down to optimize the readings for your application.

--- RELOAD ALL When “RELOAD ALL” is displayed:

1. Open the printhead and pull the media forward until a label is positioned

under the media sensor.

2. Move the ribbon back to its proper position.

3. Close the printhead.

MEDIA AND

RIBBON

CALIBRATE

Now that the scale has changed, the print engine performs a calibration equiva-

lent to pressing the CALIBRATE key. During this process, the print engine

checks the readings for the media and ribbon based on the new scale you have

established, determines the label length, and whether you are in direct thermal

or thermal transfer print mode. The process is now complete. To see the new

readings on the new scale, print a sensor profile.

Setting Communication Parameters

Communication parameters must be set correctly for the print engine to communicate with the host. These parameters

make sure that the print engine and the host are “speaking the same language.” All communications parameters are pass-

word protected.

PARALLEL COMM

Setting Parallel Communications Press the RIGHT or LEFT BLACK

OVAL key to display other choices.

Default: Parallel

Selections: Parallel, twinax/coax

Select the communications port that matches the one being used by the host

computer.

SERIAL COMM

Setting Serial Communications Press the RIGHT or LEFT BLACK

OVAL key to display other choices.

Default: RS232

Selections: RS232, RS422/485, RS485 multidrop

Select the communications port that matches the one being used by the host

computer.

BAUD

Setting Baud Press the RIGHT or LEFT BLACK OVAL key to display

other choices.

Default: 9600

Selections: 110, 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800,

38400, 57600

The baud setting of the print engine must match the baud setting of the host for

accurate communications to take place. Select the value that matches the one

being used by the host.

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 99 100

Comentarios a estos manuales

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Zebra 170PAX2 Series