Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 26)

MEDIA TYPE Setting Media Type Press the RIGHT or LEFT BLACK OVAL key to display

other choices.

Default: Continuous

Selections: Continuous, non-continuous

This parameter tells the print engine the type of media you are using. Selecting

continuous media requires that you include a label length instruction in your

label format (^LLxxxx if you are using ZPL or ZPL II).

When non-continuous media is selected, the print engine feeds media to calcu-

late label length (the distance between two detections of the inter-label gap,

webbing, or alignment notch or hole).

“Non-continuous” is the recommended mode for an applicator

SENSOR TYPE Setting the Sensor Type Press RIGHT or LEFT BLACK OVAL key to display

other choices.

Default: Web

Selections: Web, mark

This parameter tells the print engine whether you are using media with a web

(gap/space between labels, notch, or hole) to indicate the separations between

labels or if you are using media with a black mark printed on the back. If your

media does not have black marks on the back, leave your print engine at the

default (web).

PRINT METHOD Setting the Print Method Press the RIGHT BLACK OVAL key for the next

value, press the LEFT BLACK OVAL key for the previous value.

Default: Thermal transfer

Selections: Thermal transfer, direct thermal

The print method parameter tells the print engine the method of printing you

wish to use: direct thermal (no ribbon) or thermal transfer (using thermal trans-

fer media and ribbon).

NOTE: Selecting direct thermal when using thermal transfer media and

ribbon creates a warning condition, but printing will continue.

PRINT WIDTH Setting Print Width Press the RIGHT BLACK OVAL key to increase the

value, press the LEFT BLACK OVAL key to decrease the value. To change the

unit of measure, press the LEFT BLACK OVAL key until the unit of measure is

active, then press the RIGTH BLACK OVAL key to toggle to a different unit of

measure (inches, mm, or dots).

Default: 6.62” (168 mm)

Range: 1 dot (1/8 mm or 1/12 mm) to 6.62” (168 mm)

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 26