Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 12)

5. Ensure the media is aligned within the print path then close the printhead assembly

6. Secure the pinch roller (F) in position by pressing down on the top of the pinch

roller latch (G) until the assembly snaps closed.

7. Position the outer media edge guide (B) so it just touches the outer edge of the

media.

8. Raise the peel roller latch (I) and the peel roller assembly (J) will pivot down to a

vertical position.

9. Thread the backing material around the peel bar (K), under the platen roller (L), and

through the peel roller assembly (J). (See DETAIL.)

NOTE: If the applicator has an air tube, route the media between the air tube and the

peel bar. Do not thread the media over this tube!

Figure 3. Media Loading (Left-Hand Units)

OPEN

MEDIA

PATH

MEDIA

BACKING

LABEL

SEE DETAIL

OPEN

DETAIL

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 12