Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 23)

Configuration & Calibration

After you have installed the media and ribbon and the power-on self test (POST) is

complete, the front panel display will show “PRINTER READY.” (If the print engine

fails its POST, refer to “Troubleshooting” on page 49) You may now set print engine

parameters for your application using the control panel. Not all choices pertain to all

applications. Choose only those settings that apply to your particular application

NOTE: Print Engines that are operating on an IP network can be quickly configured

via ZebraNet

WebView

(optional ZebraNet PrintServer II required). For informa-

tion, refer to ZebraNet Networking: PrintServer II Installation and User’s Guide

If it becomes necessary to restore the initial print engine defaults, see “FEED Key and

PAUSE Key” on page 58.

Entering the Setup Mode

To enter the programming mode, press the SETUP/EXIT key. Press either the NEXT/

SAVE key or PREVIOUS key to scroll to the parameter you wish to set.

NOTE: You may also press and hold the NEXT/SAVE and PREVIOUS keys to

quickly advance through the configuration parameters.

Parameters in this section are shown in the order displayed when pressing the NEXT/

SAVE key. Throughout this process, press the NEXT/SAVE key to continue to the next

parameter, or press the PREVIOUS key to return to the previous parameter in the cycle.

An asterisk (*) in the upper left-hand corner of the display indicates that the value dis-

played is different than the currently stored value.

Changing Password-Protected Parameter

Certain parameters are password-protected by factory default.

CAUTION: Do not change password-protected parameters unless you are sure

you know what you are doing! If they are set incorrectly, these parameters could

cause the print engine to function in an unpredictable way.

The first attempt to change one of these parameters (pressing one of the BLACK OVAL

keys) will require you to enter a four-digit password. This is done via the “ENTER

PASSWORD” display. The LEFT BLACK OVAL key changes the selected digit posi-

tion. The RIGHT BLACK OVAL key increases the selected digit value. After entering

the password, press the NEXT/SAVE key. The parameter you wish to change will be

displayed. If the password was entered correctly, you can now change the value.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 23