Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 37)

100

HEAD TEST COUNT

Setting the Head Test Count Press the LEFT BLACK OVAL key to move

to the next digit position, press the RIGHT BLACK OVAL key to change the

value of the digit.

Default: 0000 (disables the test)

Range: 0000 to 9999

The print engine periodically performs a test of the printhead functionality,

called a “printhead test” or “head test.” This parameter establishes how many

labels are printed between these internal tests.

HEAD RESISTOR

Setting the Head Resistor Value Press the LEFT BLACK OVAL key to

move to the next digit position, press the RIGHT BLACK OVAL key to

increase the value of the digit.

CAUTION: This parameter should only be changed by qualified personnel!

Initial Value: Factory-set to match the printhead shipped with your print

engine.

Default Value: 0500

Range: 0500 to 1175

This value has been pre-set at the factory to match the resistance value of the

printhead. It will not need to be changed unless the printhead is replaced.

CAUTION: DO NOT set the value higher than that shown on the print-

head. Setting a higher value may damage the printhead!

Before replacing a printhead, look on the bottom of the printhead element for

the label that shows the resistance value (ohm value).

VERIFIER PORT

Setting the Verifier Port Press the RIGHT or LEFT BLACK OVAL key to

display other choices.

Default: Off

Selections: Off, 1 VER-RPRNT, 2 VER-THRUPUT

The auxiliary port is used to determine how the print engine will react to the

Zebra on-line verifier. There are currently three operating conditions for this

port:

• Off: The verifier port is off.

• VER-RPRNT ERR: Label reprinted if verifier detects an error. If a bar code is

near the upper edge of the label, the label will be fed out far enough to be ver-

ified and then backfed to allow the next label to be printed and verified.

• VER-THRUPUT: Allows greatest throughput but may not indicate a verifica-

tion error immediately upon detection. May print from one to three labels

before an error is recognized and printing stops.

For more information on the operation of the optional verifier, refer to the docu-

mentation provided with that option.

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 99 100

Comentarios a estos manuales

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 37

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Zebra 170PAX2 Series