Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 81)

100

5 PAUSE Input To toggle the current PAUSE state, this input must be asserted LOW for 200 millisec-

onds, or until the SERVICE REQUIRED output (pin 10) changes state.

6 REPRINT Input If the REPRINT feature is enabled – this input must be asserted LOW to cause the print

engine to reprint the last label. (See “Configuration & Calibration” on page 21)

If the REPRINT feature is disabled – this Input is ignored.

7+28V (Fused

at 1.5A)

Power Interface Power Supply – supplies power to external sensors as required.

8POWER

GROUND

(+28V

Return)

Ground Interface Power Ground.

9 RIBBON

LOW

Output If the RIBBON LOW feature is enabled, and the amount of ribbon remaining on the

supply spool is below a specific threshold level – this output will be asserted HIGH.

If the RIBBON LOW feature is disabled – this output lead is disabled. (See “Configu-

ration & Calibration” on page 21)

10 SERVICE

REQUIRED

Output While either the media cover is open, the printhead is open, the ribbon is out, the media

is out, the print engine is paused, or an operational fault has occurred, this output will

be asserted LOW.

If the applicator RESYNCH mode is set to ERROR mode, this signal will also assert

LOW for a RESYNCH error.

11 END PRINT Output MODE 0: (Default) The Applicator Port is OFF.

MODE 1: Asserted LOW only while the print engine is moving the label forward; oth-

erwise deasserted HIGH

MODE 2: Asserted HIGH only while the print engine is moving the label forward; oth-

erwise deasserted LOW.

MODE 3: Asserted LOW for 20 milliseconds when a label has been completed and

positioned. Not asserted during continuous printing.

MODE 4: Asserted HIGH for 20 milliseconds when a label has been completed and

positioned. Not asserted during continuous printing.

12 MEDIA OUT Output Asserted LOW while there is no media in the print engine.

13 RIBBON

OUT

Output Asserted LOW while there is no ribbon in the print engine.

14 DATA

READY

Output Asserted LOW when sufficient data has been received to begin printing the next label.

De-asserted HIGH whenever printing stops after the current label, due to either a

PAUSE condition or the absence of a label format.

15 SPARE Output To Be Determined

Table 10: DB-15 Connector (Printer to Applicator) (Continued)

n #

Signal

Name

Signal

Type

Functional Description

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 99 100

Comentarios a estos manuales

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 81

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Zebra 170PAX2 Series