Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 34)

100

FORMAT PREFIX

Format Prefix Character Press the LEFT BLACK OVAL key to move to

the next digit position, press the RIGHT BLACK OVAL key to increase the

value of the digit.

Default: 5E (caret)

Range: 00 - FF

The print engine looks for this 2-digit hex character to indicate the start of a

ZPL/ZPL II format instruction.

DELIMITER CHAR

Delimiter Character Press the LEFT BLACK OVAL key to move to the

next digit position, press the RIGHT BLACK OVAL key to increase the value

of the digit.

Default: 2C (comma)

Range: 00 - FF

The delimiter character is a 2-digit hex value used as a parameter place marker

in ZPL/ZPL II format instructions. Refer to the ZPL II Programming Guide Vol-

ume I for more information.

Selecting ZPL Mode

ZPL MODE

Selecting ZPL Mode Press the RIGHT or LEFT BLACK OVAL key to dis-

play other choices.

Default: ZPL II

Selections: ZPL II, ZPL

The print engine will remain in the selected mode until it is changed by this

front panel instruction or by using a ZPL/ZPL II command. The print engine

accepts label formats written in either ZPL or ZPL II. This eliminates the need

to rewrite any ZPL formats you already have. Refer to the ZPL II Programming

Guide Volume I for more information on the differences between ZPL and ZPL

II.

RIBBON TENSION

Setting Ribbon Tension Press the RIGHT or LEFT BLACK OVAL key to

display other choices.

Default: High

Selections: Low, Medium, High

This parameter sets the tension applied to the Ribbon Supply Spindle. A setting

of Low, Medium, or High is determined by the combination of ribbon width and

length. See Figure 9 on page 33 and use the chart to determine the recom-

mended setting for your specific application. If smudging or scuffing of ink on

the label material is evident, reduce the tension to the next lower setting. If rib-

bon wrinkle is evident, increase the tension to the next higher setting.

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 99 100

Comentarios a estos manuales

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Zebra 170PAX2 Series