Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 19)

Print Engine Operation

Power On/Off Switch

The Power On/Off Switch is located just to the left (or right) of the print engine’s con-

trol panel (see Figure 7 on page 18). When this switch is placed in the ON (1) position,

the POWER light goes ON and the print engine automatically performs a Power On

Self Test (POST). The Liquid Crystal Display validates the steps in the self test.

NOTE: Refer to “Troubleshooting” on page 49 if the print engine stops due to failing

a test in the Power On Self Test.

Control Panel Keys

Refer to Figure 7 on page 18. Specific uses of these keys are explained with each

parameter setting description in “Configuration & Calibration” on page 21.

Table 1: Control Panel Key Description

Key Function

Starts and stops the printing process.

• If the print engine is not printing: no printing can occur.

• If the print engine is printing: printing stops once the current label is complete.

Press to remove error messages from the display.

NOTE: Pause mode can also be activated via ZPL II (~PP, ^PP).

Forces the print engine to feed one blank label each time the key is pressed.

• Print engine not printing: one blank label immediately feeds.

• Printing: one blank label feeds after the current batch of labels is complete.

NOTE: Equivalent to the Slew to Home Position (~PH, ^PH) ZPL II instruction.

When in the pause mode, this key will cancel print jobs.

• Print job in queue: press once for each print job to be deleted.

• Press and hold for several seconds to cancel all print jobs in the print engine’s memory. The DATA

light will turn off.

When in Pause mode, this key will calibrate the print engine for:

• Media length.

• Media type (continuous or non-continuous).

• Print mode (direct thermal or thermal transfer).

• Sensor values.

NOTE: The keys below are used only when configuring the print engine. Specific uses of these keys are explained in

“Configuration & Calibration” on page 21.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 19